Remove Jeep Doors With Power Windows

One power wire goes to the battery one goes to an ignition power source and the third gets grounded in the kick panel.

Remove jeep doors with power windows.

Remove the nuts on the bottom of each bolt. Removing the doors 1. The first step in the removal of jeep doors is to loosen and remove the t50 cap nuts on the door hinges. Heavy duty connectors are installed allowing doors to be removed.

Simple 3 wire hookup. Use a 13 mm socket and turn counter clockwise to loosen the nuts. At the bottom of each of the two bolts that hold each door on the. Instructions 1 remove the door panel.

The process is basically the same for the front and rear. Lift the door straight up to disconnect it from the jeep. If you need more information on how to do that check out the door panel removal video. 3 on a manual window use the crank to roll down the window halfway to give you access to the bolt that.

The nuts are painted to match the body of the jeep so be very. It s also beneficial to lube the door stems and hinges when the doors are removed in order to make future removal easier. Be careful not to damage the paint. With the other hand grip the outside door handle.

Try putting the nuts on but just a couple turns and put a wrench on the nut and hit it the wrench with a rubber hammer and when you get the doors off put some bearing grease on the hinge and that will keep them lubed and easier to remove next time but remember to clean and regrease often. 2 pull or cut out the glued door seal to allow access inside the door. This can be done with a t50 socket and ratchet. Once you ve removed the nuts reach through the open window to grip the inside door handle.

Lift the door straight up to disconnect it.