Remove Xterra Rear Door Panel

Use the end of the removal tool to carefully pry up on the bottom rear corner of the plastic door panel.

Remove xterra rear door panel.

2007 xterra door panel removal. Remove first aid kit there are 2 screws behind it the other two are holding the grab handle on. After you remove the 4 screws gently pull the panel directly away from the hatch it will snap off. There is a front and back piece under the latch.

3 remove the arm rest. Make sure you open the back door glass first. Here are the instructions from the service manual. The panel is help by plastic clips all around the door spaces roughly 9 around.

There are only 4 screws that hold the rear panel on. Open the rear door as wide as it will go. Slide the tool under the edge of the panel to locate the first plastic clip. From here all you need to do is pry off the door panel from the door.

2 roll the window all the way up. How to remove a nissan xterra door panel. I was able to install the new deck without issue and it works great. Start at the bottom and work your way around and up.

You have only have to remove the screws on the door handle once you remove the handle just pull the panel. I know this is a simple question but i am new and wanted to start learning about customizing my 2007 xterra xe used but new for me i thought a good first step would be upgrading the cd deck and speakers. Use your panel tool to pry up the arrest and remove one exposed phillips screw. A first use a plastic trim tool to lift the rear of the arm rest and lift enough to make a small gap as shown in.

Instructions 1 turn the interior courtesy light off. Remove switches from panel trim by removing screws holding it to cover you will feed the switches through when you pull door panel remove trim under door latch by prying at seam. After removing the covers unscrew the 10mm golden screws. Pry up the panel.

There are clips around the panel. This will prevent the battery from discharging during the procedure. Press the tool against the clip until the clip is in the center of the tool and snapped into the wedge cut into the tool.