4 removing the sliding door before removing the door slide it to the point in the track where you see an indent.
Removing a sliding door lock.
Look for a small set screw at the base of the handle.
Look on the edge of the sliding glass door to locate the sliding glass door lock.
Step 3 removing the screws two screws on the end of the door secure the latch.
How to change an old mortise lock handle patio door with new 2019 parts.
Slide the door over.
Usually its the e2014 but the only way to be absolutely sure is to loosen the two screws that hold the handle on.
You have to remove the handles to see how the small actuator lever enters the latch.
Open the door and look for the latch plate along the door s edge.
These are the parts used.
Remove the screws that hold the fixed door in place in the sliding door tracks.
Step 2 screw removal.
Prime line products c 1225 sliding door handle mortise st.
On the e2014 the actuator lever is at an angle of 45 degrees.
Your lock is most likely the e2014 or the e2013 shown on my sliding door lock page.
Then replace the bottom screw in the hole where it was affixed to the handle to prevent the latch from falling into the doorframe.
Use the flat head screwdriver to turn the spindle in the center of the door lock cylinder counterclockwise until it stops.
Unscrew this plate and remove the latch from the door if possible.
The sliding glass door latch is often connected to the metal sliding glass door frame with a series of screws.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
Pull the door up from the bottom track until the wheels are out.
Taking the door out of the track 1.
At this point the square tab on the spindle is aligned with the square.
Remove this screw using a drill or screwdriver.
Unlock the sliding glass door and open it.
How to remove a door lock without a key.
The sliding glass door latch is located in the center of the frame of the door where it closes.
Once you remove all the screws lift the door up and make sure that it is completely removed from the bottom track of the door frame.
Pushing the wheels up will make it easier to.
If the fixed side of the sliding glass door is held up by a metal strip that attaches to the door jamb remove it.
Slip a flat screwdriver underneath the wheels and push them upwards.